Follow

Configuring NetScaler

Commands to Configuring a NetScaler for the First Time.

Make sure you obtain the following information before set up:

  • proper gateway (if it is on a bridged network, it will need to be the gateway ip on that vlan)
  • usable IP within your network range
  • Netmask
  • Subnetmask

 

(this can be done in the cli) 

set ns config -ipaddress<IPAddress> -netmask<subnetMask>
add ns ip<IPAddress> <subnetMask> -type<type>
add route<network> <netmask> <gateway>
set system user <userName> -password
save ns config

reboot

(you can ping from "shell" to test this configuration)

Example

 

set ns config -ipaddress 10.102.29.60 -netmask 255.255.255.0  
add ns ip 10.102.29.61 255.255.255.0 -type snip  
add route 0.0.0.0 0.0.0.0 10.102.29.1  
set system user nsroot -password  
Enter password: ***** 
Confirm password: ***** 
save ns config  
reboot


 **Only Netscaler versions 11.1 and 12 are compatible with ignite**

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments